作者：Jianxiang Chen, Liangliang Lu, Defeng Wu, Lijuan Yuan, Ming Zhang, Jingjing Hua, Jia Xu
关键字：poly(ε-caprolactone); polylactide; electrospun blend fibers; fiber reinforcements; green composite.
论文来源：期刊
具体来源：ACS Sustainable Chemistry & Engineering
发表时间：2014年

ACS Sustainable Chemistry & Engineering 2014, 2(9), 2102-2110

ABSTRACT:

As two typical aliphatic polyesters, biodegradable poly(ε-caprolactone) (PCL) and polylactide (PLA) show quite different mechanical properties. Compounding them together is therefore an interesting topic on the fabrication of biomaterials with tailorable properties. The composite technology was used in this work to prepare a new PCL/PLA system, the green PCL composites reinforced with the electrospun PLA fibers. The minor PCL was then introduced into the PLA fibers to improve reinforcing effect further. The results reveal that PLA can act as good reinforcment to PCL in the way of continuous fibers because the PCL composites reinforced with the PLA fiber mats show far higher strength and modulus than those of the neat PCL and the PCL/PLA blend samples prepared by melt mixing. In comparison with the neat PLA fibers, the PLA/PCL blend fibers have better reinforcing effect to the PCL. The presence of minor PCL component in the electrospun blend fibers improves affinity between fibers and PCL matrix by reducing fiber-matrix interfacial tension, and enhances interfacial adhesion via mutual fusion between the fiber-surface PCL phase and matrix PCL during hot compression. Both the mechanical properties and the viscoelastic responses of the composites are highly dependent on the fiber contents and PLA/PCL ratios of the blend fibers. The presence of superfluous fiber-contained PCL has no more contribution to affinity improvement, and could even decrease reinforcing effect because of degraded fiber strength. Thus, PLA/PCL weight ratio of the blend fibers is vital to final properties of the fiber-reinforced PCL green-composites. 

PDF DOWNLOAD:

http://pubs.acs.org/doi/abs/10.1021/sc500344n